How to create Wi-Fi Hotspot using command line in Windows

How to Create a WiFi Hotspot Using the Command Prompt

Here we will show how WiFi Hotspot For Windows 8.1/8/7 using Command Prompt ,How to create WiFi hotspot in windows 7/8 using Command prompt.

how WiFi Hotspot For Windows 8.1/8/7 using CMD (Command Prompt) is connected with windows computers. Share Your WiFi with all of your devices with Hotspot to Create Wi-Fi Hotspot in Windows 7/8/8.1 PC or Laptop.

Now-a-days internet connectivity has become one of the things that we need the most. It would be nice if we can use our computer's fast internet Connection. So guys the solution is Wireless Hosted Network. This concept of Wireless Hosted network was introduced in Windows 7. By using this feature we can easily create a virtual wireless adapter.To do this we only require a CMD(Command Prompt!) with Administrator privileges. And best of all you can connect to another WiFi when Hosted Network is running. This process describes some of the commands that are available only in Windows 7 or Windows 8 Ready PC

Step 1:

• Select Command Prompt(Admin) in your computer.

• Command: Windows key( ) + X

Step 2:

• Check whether your computer is supported for Hosted network or not. Type the following command in Command Prompt.

• Command : netsh wlan show drivers

If the result is “YES” then proceed to Step 3 or else download the required drivers from your vendor website.

Configuring the Hosted network connection:

Step 1:

• Type “netsh wlan set hostednetwork mode=allow ssid=yourname key=yourpassword” (enter the command without the quotations).

• Note: In this example, I have used my own user Name and Password. You can use your own parameters for SSID and KEY and Password must be greater than 8 digits.

You have successfully established the Network Connection.

Step 2:

• Start your hosted network.

• Command : netsh wlan start hostednetwork

If your Command Prompt says ” your hosted network couldn’t be started ” then make sure to turn on the “WiFi” and also enable the Wireless Adapter :)

When there is no error:

Sharing your Wireless Network Adapter

Step 1:

• Go to control Panel -> Network and Internet and select Network and Sharing Center.

Step 2:

• There you can see your newly created network under the original network connection.

Step 3:

• Select “Change adapter settings” in the left side column of Network and Sharing Center.

Step 4:

• Right click on your Wireless Network Adapter and select properties. Select the tab “Sharing“. Check the option “Allow other network users to connect through this internet’s connection” option. Mention your newly created hosted network name.

Step 5:

• Check whether your hosted network has shared the network access or not from the Network Sharing and Center.

• Wahoooo!! You have successfully turned on your WiFi Hotspot. Now you can surf internet from any device using the Hotspot.

• Here i’m going to connect my Mobile using the configured WiFi Hotspot.

• To stop the hosted network, type the command ” netsh wlan stop hostednetwork” in command prompt.

Do you think typing a command for starting/Stopping the WiFi Hotspot is a time dependent?
OK, i’m going to show you one trick so that you can Start/Stop your WiFi Hotspot in a single click.

Posted By Veersoni and Anil Haker